If the Climbing Stick happens to fall into the water or gets wet, it is important to immediately retrieve it and dry it off properly. This will help to ensure that it remains in good condition and is safe to use during your climbing excursion.
To ensure the durability of your climbing stick, it is recommended to disassemble it and give it a thorough wipe-down after extended use or when you have finished your mountain descent. Proper maintenance includes taking apart the stick, cleaning it, and storing it in a safe place. By following these steps, you can greatly extend the lifespan of your climbing stick.
To address any wear and rust on a mountaineering stick, some rust remover may be used on the affected area. However, prior to use, the surface must be cleared of any grease, which may impede the stick's adjustment and locking capabilities. To ensure the stick's lock function is unaffected, fine sanding paper can also be used to mitigate surface rust. When the stick is locked through rotation, rust powder from the support rod may fall and obstruct the locking grommet. As such, it is important to clear any rust from the grommet during maintenance, especially before the stick is combined for use. It is crucial that the grommet is completely clean and clear of any rust or grease.
Sometimes, the locking mechanism of an aluminum alloy mountaineering stick can be difficult to release. If this happens, you might try tapping the locked area lightly, or even wetting the stick to reduce friction. After that, you should be able to easily unlock the stick. Once it's unlocked, you'll want to make sure the opening is facing down so any water inside can drain out slowly. Finally, it's important to dry the climbing sticks separately and store them in a safe place.
If the locked climbing stick fails to lock due to a rotated grommet in the support rod, disassemble the support rod to clean the grommet thoroughly before reinstalling it. To do this, first rotate the support rod with the grommet until it is unlocked. Next, dismantle the support rod and insert the thinner support rod into the grommet to open it up. Then, directly insert the thicker support rod into the grommet and adjust it to the desired length before locking it again. This way, you can restore the stick and use it for your next climb without any issues.